Installation [01/2017 - ]: Procedure

Refer to PROCEDURE - Step 1

HINT: 

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Refer to INITIALIZATION [01/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 04/2020] , or refer to INITIALIZATION [04/2020 - ]

1. for Bank 1:
   1. Install the 3 ignition coil assemblies with the 3 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   2. Connect the 3 ignition coil assembly connectors.
2. for Bank 2:
   1. Install the 3 ignition coil assemblies with the 3 bolts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   2. Install the bolt.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   3. Connect the 3 ignition coil assembly connectors.
   4. Install the No. 1 engine cover sub-assembly with clip.
   5. Connect the E.F.I. vacuum sensor connector.
   6. Attach the 2 wire harness clamps.
   7. Install the 2 nuts.

      Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

See step  4

See step  6

Refer to PROCEDURE - Step 7 [01/2017 - 06/2019] , or refer to PROCEDURE - Step 7 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 7 [05/2023 - ]

Refer to PROCEDURE - Step 28

Refer to PROCEDURE - Step 29

Refer to PROCEDURE - Step 118 [01/2017 - 06/2019] , or refer to PROCEDURE - Step 118 [06/2019 - 05/2023] , or refer to PROCEDURE - Step 118 [05/2023 - ]