Removal [12/2017 - ]: Procedure
- REMOVE ENGINE AND TRANSMISSION ASSEMBLY (for AWD)
Refer to REMOVAL [12/2017 - 09/2018] , or refer to REMOVAL [09/2018 - 10/2020] , or refer to REMOVAL [10/2020 - 10/2022] , or refer to REMOVAL [10/2022 - 10/2023] , or refer to REMOVAL [10/2023 - ]
- DISCONNECT FRONT FRAME ASSEMBLY (for AWD)
Refer to PROCEDURE - Step 141 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 141 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 141 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 141 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 141 [10/2023 - ]
- REMOVE FRONT ENGINE MOUNTING INSULATOR (for AWD)
Refer to PROCEDURE - Step 142 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 142 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 142 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 142 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 142 [10/2023 - ]
- REMOVE NO. 2 MANIFOLD STAY (for AWD)
- REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH (for AWD)
Refer to PROCEDURE - Step 163 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 163 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 163 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 163 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 163 [10/2023 - ]
- REMOVE TRANSMISSION UNDER COVER (for 2WD)
Refer to PROCEDURE - Step 16 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 16 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 16 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 16 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 16 [10/2023 - ]
- REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY (for 2WD)
Refer to PROCEDURE - Step 17 [12/2017 - 09/2018] , or refer to PROCEDURE - Step 17 [09/2018 - 10/2020] , or refer to PROCEDURE - Step 17 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 17 [10/2022 - 10/2023] , or refer to PROCEDURE - Step 17 [10/2023 - ]
- REMOVE CRANKSHAFT POSITION SENSOR
- Disconnect the crankshaft position sensor connector.
- Remove the bolt and crankshaft position sensor.NOTE:
If the crankshaft position sensor has been struck or dropped, replace it.
- When reusing the crankshaft position sensor:
- Remove the O-ring from the crankshaft position sensor.NOTE:
- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the crankshaft position sensor.
- If the O-ring groove is damaged, replace the crankshaft position sensor.
- Remove the O-ring from the crankshaft position sensor.
- Disconnect the crankshaft position sensor connector.