Removal [09/2014 - 03/2019]: Procedure

PRECAUTION
NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Refer to PRECAUTION [09/2014 - 11/2017] , or refer to PRECAUTION [11/2017 - ]
REMOVE FRONT WHEEL
Refer to PROCEDURE - Step 1
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [09/2014 - 08/2016] , or refer to INITIALIZATION [08/2016 - 11/2017] , or refer to INITIALIZATION [11/2017 - 03/2019]
SEPARATE FRONT FENDER LINER

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Remove the screw and separate the front fender liner.

REMOVE FRONT SKID CONTROL SENSOR WIRE

Disconnect the pad wear indicator wire connector from the front skid control sensor wire.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Pad Wear Indicator Wire
*2	Front Skid Control Sensor Wire

Disconnect the front skid control sensor wire connector from the front axle hub sub-assembly.
Remove the bolt and sensor clamp from the steering knuckle.

Remove the 2 bolts and 2 sensor clamps from the front shock absorber assembly and vehicle body.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for LH Side:

Disengage the clamp from the front No. 1 stabilizer bracket LH.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for RH Side:

Disengage the 2 clamps from the front No. 1 stabilizer bracket RH and vehicle body.