Precaution [09/2014 - 11/2017]

When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.

• The power window control system uses the LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the power window control system after confirming that the communication system is functioning properly.

  Refer to HOW TO PROCEED WITH TROUBLESHOOTING [09/2014 - ] 

• The power window control system prohibits the auto up and down function if the jam protection function malfunctions.
• The power window control system prohibits the auto up and down function if the catch protection function malfunctions.
• If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.

  Refer to INITIALIZATION [09/2014 - ] 

• If a power window regulator motor assembly and door window regulator sub-assembly have been removed and installed, or if a power window regulator motor assembly was reused when a door glass or door glass run was replaced, initialize the power window control system.

  Refer to INITIALIZATION [09/2014 - ] 

• The jam protection function and the catch protection function may operate unexpectedly, even when the power window control system is normal, due to detection of a value different than the operation learned value when the door glass moving speed changes sharply under any of the following conditions:
  1. A power window is being opened or closed while the vehicle is driven on a rough road.
  2. A power window is being opened or closed while the door is being opened or closed.
  3. The voltage changes abruptly.
• Do not disconnect the battery while the engine switch is on (IG). Otherwise, DTC B2313 will be stored.

  Refer to DTC B2313: Glass Position Initialization Incomplete [09/2014 - ]