Installation [08/2020 - ]: Procedure

Refer to PROCEDURE - Step 1

HINT: 

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Refer to INITIALIZATION [08/2020 - ]

1. Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

   Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

   NOTE:

   If an ignition coil assembly has been struck or dropped, replace it.

   HINT: 

   Install the same parts to their original positions.

2. Connect the 4 ignition coil assembly connectors.

Refer to PROCEDURE - Step 48 [08/2020 - 08/2021] , or refer to PROCEDURE - Step 49 [08/2021 - ]

1. Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

   Refer to INITIALIZATION [08/2020 - ]