How To Proceed With Troubleshooting [08/2020 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard Voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to DIAGNOSIS SYSTEM [08/2020 - 08/2021] , or refer to DIAGNOSIS SYSTEM [08/2021 - 09/2022] , or refer to DIAGNOSIS SYSTEM [09/2022 - ]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING). Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2018 - ] 

Result: 

A 

See step  4

1. Check for DTCs.

   Chassis > Four Wheel Drive > Trouble Codes 

2. Check for freeze frame data.

   HINT: 

   Record or print DTCs and freeze frame data if necessary.

3. Clear the DTCs and freeze frame data.

   Chassis > Four Wheel Drive > Clear DTCs 

4. Recheck for DTCs.

   Chassis > Four Wheel Drive > Trouble Codes 

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

Result: 

B 

See step  7

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2020 - ] 

   Result

   Result	Proceed to
   Fault not listed in problem symptoms table	A
   Fault listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Terminals of ECU.

   Refer to TERMINALS OF ECU [08/2020 - ] 

2. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [08/2020 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END