Removal [06/2018 - 08/2021]: Procedure

PRECAUTION
NOTE:
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Refer to PROCEDURE - Step 1
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 18 [06/2018 - 08/2020] , or refer to PROCEDURE - Step 18 [08/2020 - 08/2021]

REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY

Disconnect the cam timing control motor with EDU assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the 3 bolts and cam timing control motor with EDU assembly from the No. 2 timing gear cover assembly.
NOTE:
If the cam timing control motor with EDU assembly has been struck or dropped, replace it.

REMOVE CAM TIMING CONTROL MOTOR O-RING

Remove the cam timing control motor O-ring from the No. 2 timing gear cover assembly.