Inspection [06/2018 - ]: Procedure
- INSPECT BRAKE HOLD SWITCH (NO. 2 COMBINATION SWITCH ASSEMBLY)
- Make sure that there is no looseness in the locking part and the connecting part of the connector.
*a Component without harness connected
(Brake Hold Switch (No. 2 Combination Switch Assembly))OK
The connector is securely connected.
- Disconnect the brake hold switch (No. 2 combination switch assembly) connector.
- Check both the connector case and the terminal for deformation and corrosion.
OK
No deformation or corrosion.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 4 (+B) - 2 (E) Switch pushed Below 1 Ω 4 (+B) - 2 (E) Switch not pushed 10 kΩ or higher HINT:
If the result is not as specified, replace the brake hold switch (No. 2 combination switch assembly).
- Make sure that there is no looseness in the locking part and the connecting part of the connector.