Installation [08/2015 - ]: Procedure

1. Install the speed sensor with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   • Make sure there are no pieces of iron or other foreign matter attached to the sensor tip.
   • While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip.
   • After installing the speed sensor, make sure there is no clearance or foreign matter between the sensor stay part and the knuckle.
   • Make sure there is no foreign matter attached to the speed sensor rotor.

1. Install the skid control sensor clamp with the bolt.

   Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

   NOTE:

   Install the clamp so that the rotation stopper touches the knuckle.

1. Connect the connector as follows.
   1. for LH:

      1. Attach the connector, and then connect the connector.

      NOTE:

      Securely connect the connector.

   2. for RH:

      1. Install the skid control sensor clamp with the bolt.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

      NOTE:

      Make sure the clamp rotation stopper touches the installation position.

      2. Attach the connector, and then connect the connector.

      NOTE:

      • Securely connect the connector.
      • When connecting the connector, do not twist the wire harness.

      3. Attach the clip.

2. Install the 2 harness clamps with the 2 bolts.

   Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

   NOTE:

   • When installing the clamps, do not twist the wire harness.
   • Make sure the clamp rotation stopper touches the installation position.
3. Install the 2 harness clamps with the 2 bolts.

   Torque: 13 N*m (127 kgf*cm, 9 ft.*lbf) 

   NOTE:

   • When installing the clamps, do not twist the wire harness.
   • Make sure the clamp rotation stopper touches the installation position.
4. Attach the clip.
5. Connect the connector.
   NOTE:

   Securely connect the connector.

Torque: 112 N*m (1137 kgf*cm, 82 ft.*lbf) 

1. Check the speed sensor signal (Refer to TEST MODE PROCEDURE [08/2015 - 08/2019] , or refer to TEST MODE PROCEDURE [08/2019 - 08/2021] , or refer to TEST MODE PROCEDURE [08/2021 - ] ).