DTC P060B: Internal Control Module A/D Processing Performance [08/2015 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - ] ).
5. Turn the Techstream off.
6. Turn the engine switch off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the engine switch on (IG) and turn the Techstream on.
12. Wait 16 seconds or more.
13. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
14. Check for DTCs.
    RESULT
    
    

    Result	Proceed to
    No output	A
    P060B is output	B
    P060B and P0327, P0328, P032C, P032D, P0332, P0333, P033C or P033D are output	C

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2015 - ] )

Result: 

B 

REPLACE ECM 

(Refer to REMOVAL [08/2015 - ] )

Result: 

C 

GO TO DTC P0327, P0328, P032C, P032D, P0332, P0333, P033C OR P033D 

(Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor); DTC P032C: Knock Sensor 3 Circuit Low; DTC P032D: Knock Sensor 3 Circuit High; DTC P0332: Knock Sensor 2 Circuit Low Input (Bank 2); DTC P0333: Knock Sensor 2 Circuit High Input (Bank 2); DTC P033C: Knock Sensor 4 Circuit Low Input; DTC P033D: Knock Sensor 4 Circuit High Input [08/2015 - ] )