Installation [08/2015 - ]: Procedure

1. Install a new O-ring to the power steering oil pressure switch.
2. Apply a light coat of engine oil to the O-ring.
3. Using SST, install the power steering oil pressure switch.
   • SST: 09922-10010 

   without SST 

   Torque: 21 N*m (210 kgf*cm, 15 ft.*lbf) 

   with SST 

   Torque: 15 N*m (148 kgf*cm, 11 ft.*lbf) 

   TEXT IN ILLUSTRATION
   
   

   *1	Fulcrum Length

   HINT: 

   • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification (Refer to PRECAUTION [08/2015 - ] ).
   • Make sure SST and the torque wrench are connected in a straight line.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

4. Connect the power steering oil pressure switch connector.

1. Install the fan and generator V belt (Refer to INSTALLATION [08/2015 - ] ).

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 84 [08/2015 - 08/2020] , or refer to PROCEDURE - Step 84 [08/2020 - ]

Torque: 112 N*m (1137 kgf*cm, 82 ft.*lbf)