Installation [08/2015 - 08/2019]: Procedure

INSTALL SEAT BELT CONTROL ECU
1. Install the seat belt control ECU with the bolt.
  Torque: 7.0 N*m (71 kgf*cm, 62 in.*lbf)
2. Connect the 2 connectors.
INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
Refer to PROCEDURE - Step 1
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
Refer to PROCEDURE - Step 24
INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 62 [08/2015 - 08/2016] , or refer to PROCEDURE - Step 62 [08/2016 - 08/2019]
INSTALL DOOR SCUFF PLATE ASSEMBLY LH
Refer to PROCEDURE - Step 64 [08/2015 - 08/2016] , or refer to PROCEDURE - Step 64 [08/2016 - 08/2019]
INSTALL INSTRUMENT PANEL FINISH PANEL END LH
Refer to PROCEDURE - Step 7
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [08/2015 - 08/2019] ).
CHECK SRS WARNING LIGHT
1. Check the SRS warning light (Refer to DIAGNOSIS SYSTEM [08/2015 - 08/2019] ).