How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to PRECAUTION [08/2015 - ]

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

A 

See step  4

1. Check if the LIN communication system is functioning normally.

   Result

   Result	Proceed to
   LIN DTC is not output	A
   LIN DTC is output	B

Result: 

B 

GO TO LIN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2019]  , or refer to  HOW TO PROCEED WITH TROUBLESHOOTING [08/2019 - ] 

Result: 

A 

See step  5

1. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [08/2015 - ] 

2. Recheck for DTCs.

   Result

   Result	Proceed to
   No DTCs are output	A
   DTC B2311 is output	A
   DTC B2312 is output	B
   DTC B2313 is output	B

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]  

Result: 

A 

See step  6

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [08/2015 - ] 

   Result

   Result	Proceed to
   Fault not listed in problem symptoms table	A
   Fault listed in problem symptoms table	B

Result: 

B 

See step  8

Result: 

A 

See step  7

1. Operation Check.

   Refer to OPERATION CHECK [08/2015 - 08/2016] , or refer to OPERATION CHECK [08/2016 - ] 

2. Terminals of ECU.

   Refer to TERMINALS OF ECU [08/2015 - 08/2019] , or refer to TERMINALS OF ECU [08/2019 - ] 

3. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [08/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  8

Result

Result: 

B 

See step  10

Result: 

A 

See step  9

1. Initialize the power window regulator motor.

   Refer to INITIALIZATION [08/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

END