On-Vehicle Inspection [10/2017 - 09/2020]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.

Refer to INITIALIZATION [10/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 09/2020]

1. Read the value using the Techstream (Mass Air Flow Sensor).
   NOTE:

   • Perform the inspection with the vehicle indoors and on a level surface.
   • Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).
   • During the test, do not use an exhaust air duct on the exhaust pipe.
   1. Connect the Techstream to the DLC3.
   2. Turn the engine switch on (IG) (do not start the engine).
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Engine / Data List / Mass Air Flow Sensor.

      Powertrain > Engine > Data List 

      Tester Display
      Mass Air Flow Sensor

   5. Wait for 30 seconds, and read the value on the Techstream.

      Standard Condition

      Tester Display	Condition	Specified Condition
      Mass Air Flow Sensor	Engine not running 30 seconds after engine switch turned on (IG)	0.54 gm/sec or less

      If the result is not as specified, clean the mass air flow meter sub-assembly.

      Refer to INSPECTION [10/2017 - ] 

      If the result is within the specified range, check the intake air temperature sensor (thermistor) resistance.

      Refer to INSPECTION [10/2017 - ]