How To Proceed With Troubleshooting [07/2020 - 05/2023]: Procedure
- VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to NEXT Result:
NEXT
See step 2
- INSPECT BATTERY VOLTAGE
- Measure the battery voltage with the engine switch off.
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to NEXT
Result:
NEXT
See step 3
- Measure the battery voltage with the engine switch off.
- CHECK COMMUNICATION FUNCTION OF CXPI COMMUNICATION SYSTEM*
- Using the Techstream, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
Refer to DTC CHECK / CLEAR [07/2020 - ]
Result
Proceed to No DTCs output DTCs output
Result:
DTCs output
GO TO CXPI COMMUNICATION SYSTEM. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [07/2020 - ]
Result:
No DTCs output
See step 4
- Using the Techstream, check the CXPI communication function to ensure that there are no malfunctions in the communication system.
- CHECK FOR DTC*
- Check for DTCs and make a note of any codes that are output.
- Clear the DTCs.
- No. 1 semiconductor power integration ECU
Body Electrical > Power Integration No. 1 > Clear DTCs
- No. 2 semiconductor power integration ECU
Body Electrical > Power Integration No. 3 > Clear DTCs
- No. 1 semiconductor power integration ECU
- Recheck for DTCs.
- No. 1 semiconductor power integration ECU
Body Electrical > Power Integration No. 1 > Trouble Codes
- No. 2 semiconductor power integration ECU
Body Electrical > Power Integration No. 3 > Trouble Codes
Result
Proceed to No DTCs output DTCs output - No. 1 semiconductor power integration ECU
Result:
DTCs output
GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [07/2020 - 05/2023]
Result:
No DTCs output
See step 5
- PROBLEM SYMPTOMS TABLE
- Refer to the Problem Symptoms Table.
Refer to PROBLEM SYMPTOMS TABLE [07/2020 - 05/2023]
Result
Proceed to Fault is not listed in problem symptoms table Fault is listed in problem symptoms table
Result:
Fault is listed in problem symptoms table
ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
Result:
Fault is not listed in problem symptoms table
See step 6
- Refer to the Problem Symptoms Table.
- OVERALL ANALYSIS AND TROUBLESHOOTING*
- Data List / Active Test
- Terminals of ECU
Refer to TERMINALS OF ECU [07/2020 - 05/2023]
- Problem symptoms table
Refer to PROBLEM SYMPTOMS TABLE [07/2020 - 05/2023]
Result
Proceed to NEXT
Result:
NEXT
See step 7
- ADJUST, REPAIR OR REPLACE
Result
Proceed to NEXT Result:
NEXT
END