Installation [07/2020 - ]: Procedure

1. Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly RH.
   NOTE:

   Do not damage the O-ring.

2. Install the camshaft timing oil control valve assembly RH to the cylinder head cover sub-assembly with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   NOTE:

   • If the camshaft timing oil control valve assembly RH has been struck or dropped, replace it.
   • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly RH (connecting surface with the cylinder head cover sub-assembly).
   • Make sure that the O-ring is not cracked or does not move out of place during installation.
3. Connect the camshaft timing oil control valve assembly RH connector.

1. Apply a light coat of engine oil to a new O-ring and install it to the camshaft timing oil control valve assembly LH.
   NOTE:

   Do not damage the O-ring.

2. Install the camshaft timing oil control valve assembly LH to the cylinder head cover sub-assembly LH with the bolt.

   Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

   NOTE:

   • If the camshaft timing oil control valve assembly LH has been struck or dropped, replace it.
   • Do not allow foreign matter to contact the oil seal face of the camshaft timing oil control valve assembly LH (connecting surface with the cylinder head cover sub-assembly LH).
   • Make sure that the O-ring is not cracked or does not move out of place during installation.
3. Connect the camshaft timing oil control valve assembly LH connector.

Refer to PROCEDURE - Step 147 [07/2020 - 05/2023] , or refer to PROCEDURE - Step 150 [05/2023 - ]