Installation [12/2017 - 10/2020]: Procedure

1. Install the battery state sensor assembly to the battery and tighten the nut.

   Torque: 6.4 N.m (65 kgf/cm, 57 in.lbf) 

2. Connect the wire harness to the battery state sensor assembly with the nut.

   Torque: 10.2 N.m (104 kgf/cm, 8 ft.lbf) 

   NOTE:

   When disconnecting the wire harness, some systems need to be initialized after the wire harness is reconnected.

   Refer to INITIALIZATION [12/2017 - 09/2018] , or refer to INITIALIZATION [09/2018 - 10/2020]

3. Connect the battery state sensor assembly connector.

Refer to PROCEDURE - Step 3

Refer to PROCEDURE - Step 11