LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2021 >> LS 500 Base, RWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Control System - Service Information >> Accelerator Pedal >> On-Vehicle Inspection [12/2017 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

On-Vehicle Inspection [12/2017 - ]: Procedure

  1. INSPECT ACCELERATOR PEDAL SENSOR ASSEMBLY 
    1. Warm up the engine.
    2. Turn the A/C switch off.
    3. Turn the engine switch off.
    4. Connect the Techstream to the DLC3.
    5. Turn the engine switch on (IG).
    6. Turn the Techstream on.
    7. Enter the following menus: Powertrain / Engine / Data List / Accelerator Position Sensor No. 1 Voltage and Accelerator Position Sensor No. 2 Voltage.

      Powertrain > Engine > Data List 

      Tester Display
      Accelerator Position Sensor No. 1 Voltage
      Accelerator Position Sensor No. 2 Voltage
    8. Read the values displayed on the Techstream.

      Standard Voltage

      Tester Display Condition Specified Condition
      Accelerator Position Sensor No. 1 Voltage Accelerator pedal fully released 0.5 to 1.1 V
      Accelerator pedal fully depressed 2.6 to 4.5 V
      Accelerator Position Sensor No. 2 Voltage Accelerator pedal fully released 1.2 to 2.0 V
      Accelerator pedal fully depressed 3.4 to 4.75 V

      If the result is not as specified, check the accelerator pedal sensor assembly, wire harness and ECM.

scientia non olet · About LEMON Manuals