Installation [10/2020 - 10/2023]: Procedure

1. for LH Side:
   1. Connect the connector.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   2. Install the acceleration sensor with the 2 nuts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

      NOTE:

      • Avoid any impact to the acceleration sensor.
      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
   3. Return the floor carpet to its original position.
2. for RH Side:
   1. Connect the connector.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   2. Install the acceleration sensor with the 2 nuts.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

      NOTE:

      • Avoid any impact to the acceleration sensor.
      • Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
   3. Return the floor carpet to its original position.

Refer to PROCEDURE - Step 34 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 33 [10/2022 - 10/2023]

Refer to PROCEDURE - Step 35 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 34 [10/2022 - 10/2023]

Refer to PROCEDURE - Step 36 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 35 [10/2022 - 10/2023]

Refer to PROCEDURE - Step 42 [10/2020 - 11/2021] , or refer to PROCEDURE - Step 42 [11/2021 - 10/2023]

HINT: 

Use the same procedure described for the LH side.

Refer to PROCEDURE - Step 39 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 38 [10/2022 - 10/2023]

Refer to PROCEDURE - Step 40 [10/2020 - 10/2022] , or refer to PROCEDURE - Step 39 [10/2022 - 10/2023]

HINT: 

Use the same procedure described for the LH side.

Refer to INSTALLATION [10/2020 - 10/2023]

Refer to WORK PROCEDURE [10/2020 - 10/2022] , or refer to WORK PROCEDURE [10/2022 - 10/2023]

HINT: 

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [10/2020 - 10/2023]