Installation [10/2014 - 05/2019]: Procedure

1. Install the No. 2 ECM bracket to the ECM with the 2 screws.

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

1. Install the No. 1 ECM bracket to the ECM with the 2 screws.

   Torque: 3.0 N.m (31 kgf/cm, 27 in.lbf) 

1. Install the ECM with the 3 bolts.

   Torque: 6.5 N.m (66 kgf/cm, 58 in.lbf) 

   NOTE:

   Replace with a new part if it is dropped or if it receives a strong impact.

2. Connect the 2 ECM connectors and lock with the 2 levers.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • When connecting a connector, make sure that dirt, water and other foreign matter is not stuck between the connector and ECM.
   • Make sure that the 2 levers are securely lowered.

1. Insert the pin of the air cleaner case sub-assembly to the grommet of the engine mounting insulator LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Pin
   *b	Grommet

2. Install the air cleaner case sub-assembly with the 2 bolts.

   Torque: 5.0 N.m (51 kgf/cm, 44 in.lbf) 

3. Attach the 3 wire harness clamps to connect the wire harness to the air cleaner case assembly.

1. Install the air cleaner filter element sub-assembly.

1. Attach the 2 clips to install the air cleaner cap sub-assembly.
2. Tighten the hose clamp to secure the air cleaner cap sub-assembly.
3. Attach the wire harness clamp to connect the wire harness to the air cleaner cap sub-assembly.
4. Connect the intake mass air flow meter sub-assembly connector.

Refer to PROCEDURE - Step 5 [10/2014 - 05/2018] , or refer to PROCEDURE - Step 5 [05/2018 - 05/2019]

Refer to PROCEDURE - Step 6 [10/2014 - 05/2018] , or refer to PROCEDURE - Step 6 [05/2018 - 05/2019]

Refer to PROCEDURE - Step 7 [10/2014 - 05/2018] , or refer to PROCEDURE - Step 7 [05/2018 - 05/2019]

Refer to INITIALIZATION [10/2014 - 09/2017] , or refer to INITIALIZATION [09/2017 - 05/2019]