Installation [10/2014 - 07/2020]: Procedure

1. Install the front speed sensor LH to the steering knuckle with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   • Prevent foreign matter from attaching to the front speed sensor tip.
   • Firmly insert the front speed sensor body into the steering knuckle before tightening the bolt.
2. Install the sensor clamp as follows.
   1. Attach hook A and B of the sensor clamp to the flexible hose bracket.

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      *1	Absorber Bracket
      *2	Flexible Hose Clamp

      NOTE:

      Do not twist the wire harness for the sensor clamp when installing it.

   2. Install the flexible hose clamp together with the sensor clamp to the absorber bracket with the bolt.

      Torque: 18.8 N*m (192 kgf*cm, 14 ft.*lbf) 

   3. Install the clamp to the absorber bracket.
3. Install the sensor clamp to the side member with the bolt.

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   Do not twist the wire harness for the sensor clamp when installing it.

4. Install the clamp.
5. Fold back the fender liner and connect the connector.

Refer to INSTALLATION [10/2014 - ]

Refer to TEST MODE PROCEDURE [10/2014 - 09/2016] , or refer to TEST MODE PROCEDURE [09/2016 - 05/2019] , or refer to TEST MODE PROCEDURE [05/2019 - ]