Installation [10/2014 - ]: Procedure

1. Apply a light coat of engine oil to a new O-ring and install the O-ring to the camshaft timing oil control valve assembly.
   NOTE:

   Do not damage the O-ring when installing.

   HINT: 

   An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.

2. Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

   Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

   NOTE:

   • Replace with a new part if it is dropped or if it receives a strong impact.
   • Make sure that the O-ring is not cracked or jammed when installing.
3. Connect the camshaft timing oil control valve assembly connector.

Refer to PROCEDURE - Step 6

Refer to PROCEDURE - Step 94 [10/2014 - 05/2019], or refer to PROCEDURE - Step 95 [05/2019 - ]