On-Vehicle Inspection [10/2014 - ]: Procedure
- CHECK MANIFOLD ABSOLUTE PRESSURE SENSOR FUNCTION
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.
Powertrain > Engine and ECT > Data List
Tester Display MAP - Read the values displayed on the Techstream.
Standard Condition
80 to 110 kPa (0.8 to 1.1 kgf/cm2 , 12 to 16 psi)
- Using the vacuum pump, measure the manifold absolute pressure sensor when a pressure of 67 kPa (503 mmHg, 19.8 in.Hg) is applied to the manifold absolute pressure sensor.
Standard Condition
23 to 38 kPa (173 to 285 mmHg, 6.79 to 11.2 in.Hg)