DTC P060A: Internal Control Module Monitoring Processor Performance [10/2014 - 05/2019]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [10/2014 - 05/2019]

   Powertrain > Engine and ECT > Clear DTCs 

5. Turn the Techstream off.
6. Turn the power switch off.
7. Disconnect the Techstream.
8. Disconnect the cable from the negative (-) auxiliary battery terminal and wait for 1 minute.
9. Connect the cable to the negative (-) auxiliary battery terminal.
10. Connect the Techstream to the DLC3.
11. Turn the power switch on (IG).
12. Turn the Techstream on.
13. Wait for 16 seconds or more.
14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
15. Read the DTCs.

    Powertrain > Engine and ECT > Trouble Codes 

    Result

    Result	Proceed to
    DTCs are not output	A
    DTC P060A is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  CHECK FOR INTERMITTENT PROBLEMS [10/2014 - ] 

Result: 

B 

REPLACE ECM. Refer to  REMOVAL [10/2014 - ]