Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated) [09/2014 - ]: Procedure

1. Initialize the power window regulator motor assembly (applicable location).

   Refer to INITIALIZATION [09/2014 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Check that each power window moves when the auto up and down functions of the multiplex network master switch assembly or power window regulator switch assembly are operated.

   Refer to OPERATION CHECK [09/2014 - ]

   OK

   Auto up and down function is normal (applicable location).

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

See step  3

1. Remove the power window regulator motor assembly and door window regulator sub-assembly.
2. Install the door glass to the roof side rail weatherstrip.
3. Check that the power window regulator motor assembly and door window regulator sub-assembly operate smoothly.
4. Check that the door glass slides smoothly when sliding it up by hand.
   NOTE:

   Make sure to perform initialization.

   HINT: 

   Ensure the following: 

   • The door glass fits in the roof side rail weatherstrip without improper contact or deformation.
   • Foreign matter is not caught in the roof side rail weatherstrip.
   • The roof side rail weatherstrip is not misaligned.
   • The door glass is not tilted and does not catch on the belt molding or roof side rail weatherstrip.

   OK

   Door glass slides smoothly.

   Result

   Result	Proceed to
   OK (Driver door power window)	A
   OK (Front passenger door power window)
   NG	B

Result: 

A 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to  REMOVAL [09/2014 - ] 

Result: 

B 

FIT DOOR GLASS CORRECTLY (REMOVE FOREIGN MATTER CAUSING IMPROPER FIT OR REPLACE PARTS)