LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2021 >> RC F Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - Diagnostic Codes (6 Of 9) >> SFI System >> DTC P0607: Control Module Performance [09/2014 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P0607: Control Module Performance [09/2014 - ]: Procedure

  1. CHECK FOR ANY OTHER DTCS OUTPUT 
    1. Connect the Techstream to the DLC3.
    2. Turn the engine switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Powertrain / Engine / Trouble Codes.
    5. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTC P0607 and P0136, P0137, P0138, P0156, P0157 or P0158 are output A
      DTC P0607 is output B

    Result: 

    B 

    See step  3

    Result: 

    A 

    See step  2

  2. INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) 
    1. Refer to the P0136, P0137, P0138, P0156, P0157 or P0158 flowchart.

      HINT: 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  3. CHECK FOR EXHAUST GAS LEAK 
    1. Allow the engine to idle and then rev the engine.
    2. Check for exhaust gas leaks around the heated oxygen sensor.

      If any exhaust gas leaks are present, repair them and proceed to "Perform Confirmation Driving Pattern". If no exhaust gas leaks are present, proceed to "Perform Confirmation Driving Pattern".

      HINT: 

      • If no exhaust gas leaks are present, there may be a malfunction in the heated oxygen sensor circuit.
      • If any exhaust gas leaks are present around the heated oxygen sensor, noise appears in the output voltage of the heated oxygen sensor.
      • Perform "Inspection After Repair" after repairing or replacing the exhaust system.

        Refer to INITIALIZATION [09/2014 - ]

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  4

  4. PERFORM CONFIRMATION DRIVING PATTERN 
    GTY317022Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Connect the Techstream to the DLC3.
    2. Start the engine.
    3. Turn the Techstream on.
    4. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - ]

      Powertrain > Engine > Clear DTCs 

    5. Warm up the engine until the engine coolant temperature becomes 75°C (167°F) or higher.
    6. Perform the driving pattern.
      WARNING:

      When performing the confirmation driving pattern, obey all speed limits and traffic laws.

      1. Accelerate the vehicle until 80 km/h (50 mph) and stop the vehicle.
      2. Drive the vehicle between 60 to 80 km/h (37 to 50 mph) for 5 minutes.
    7. Enter the following menus: Powertrain / Engine / Trouble Codes.
    8. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTC P0607 and P0136, P0137, P0138, P0156, P0157 or P0158 are output A
      DTC P0607 is output B
      DTCs are not output C

    Result: 

    B 

    REPLACE ECM. Refer to  REMOVAL [09/2014 - ] 

    Result: 

    C 

    See step  6

    Result: 

    A 

    See step  5

  5. INSPECT DTC (P0136, P0137, P0138, P0156, P0157 OR P0158) 
    1. Refer to the P0136, P0137, P0138, P0156, P0157 or P0158 flowchart.

      HINT: 

      Result

      Proceed to
      NEXT

    Result: 

    NEXT 

    See step  6

  6. INSPECT ECM 
    1. Clear the DTCs.

      Refer to DTC CHECK / CLEAR [09/2014 - ]

      Powertrain > Engine > Clear DTCs 

    2. Stop the engine and wait for 30 minutes.
    3. Connect the Techstream to the DLC3.
    4. Start the engine and allow it to idle for 2 minutes.
    5. Turn the Techstream on.
    6. Enter the following menus: Powertrain / Engine / Trouble Codes.
    7. Read the DTCs.

      Powertrain > Engine > Trouble Codes 

      Result

      Result Proceed to
      DTCs are not output A
      DTC P0607 is output B

    Result: 

    A 

    END 

    Result: 

    B 

    REPLACE ECM. Refer to  REMOVAL [09/2014 - ] 

scientia non olet · About LEMON Manuals