General Maintenance [09/2014 - ]: Procedure

TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY
1. If necessary, tighten the bolts and nuts on the chassis parts listed below.
  - Front axle and suspension
  - Drivetrain
  - Rear axle and suspension
  - Brake system
  - Engine mounts
  - Other chassis parts
2. If necessary, tighten the bolts and nuts on the body parts listed below.
  - Seat belt system
  - Seats
  - Doors and hood
  - Body mounts
  - Fuel tank
  - Exhaust system
  - Other body parts
CLEAN OR REPLACE AIR CONDITIONING FILTER
1. Remove the air conditioning filter.
  Refer to PROCEDURE - Step 1
2. Visually inspect the surface of the air conditioning filter.
3. If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.
  NOTE:
  Some filters are not able to be cleaned.
ROAD TEST
1. Check the engine and chassis for abnormal noises.
2. Check that the vehicle does not wander or pull to one side.
3. Check that the brakes work properly and do not drag.
4. Bed-in the parking brake shoes to the drums.
BODY INSPECTION
1. Check the body exterior for dents, scratches and rust.
2. Check the underbody for rust and damage.
  If necessary, replace any damaged parts or repair any damaged areas.
FINAL INSPECTION
1. Check the operation of the body parts.
  1. Hood
    - Auxiliary catch operates properly.
    - Hood locks securely when closed.
  2. Front and rear doors
    - Door locks operate properly.
    - Doors close properly.
  3. Luggage compartment door
    - Luggage compartment door opens and closes properly.
  4. Seats
    - Seats adjust easily and lock securely in any position.
    - Front seatbacks lock securely in any position.
    - Fold-down rear seatbacks lock securely.
  5. Be sure to deliver a clean car. Make sure to check the following:
    - Steering wheel
    - Shift lever knob
    - All switches and knobs
    - Door handles
    - Seats