Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [09/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master switch / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Master Switch > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver door power window auto switch signal	OFF or ON	OFF: Driver door power window auto switch not being operated ON: Driver door power window auto switch being operated	-

   Body Electrical > Master Switch > Data List 

   Tester Display
   D Door P/W Auto SW

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY. Refer to  REMOVAL [09/2014 - ] 

Result: 

OK 

See step  2

1. Enter the following menus: Body Electrical / D-Door Motor / Data List.
2. Read the Data List according to the display on the Techstream.

   Body Electrical > D-Door Motor > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver door power window auto switch signal	OFF or ON	OFF: Driver door power window auto switch not being operated ON: Driver door power window auto switch being operated	-

   Body Electrical > D-Door Motor > Data List 

   Tester Display
   D Door P/W Auto SW

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

See step  5

Result: 

OK 

See step  3

1. Initialize the power window regulator motor assembly (for driver door).

   Refer to INITIALIZATION [09/2014 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly are operated.

   Refer to OPERATION CHECK [09/2014 - ]

   OK

   Driver door auto up and down functions are normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (PROBLEM DUE TO INITIALIZATION FAILURE) 

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR). Refer to  REMOVAL [09/2014 - ] 

1. Replace the multiplex network master switch assembly.

   Refer to REMOVAL [09/2014 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  6

1. Check that the driver door power window moves when the auto up and down function of the multiplex network master switch assembly is operated.

   Refer to OPERATION CHECK [09/2014 - ]

   OK

   Driver door auto up and down functions are normal.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WAS DEFECTIVE) 

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR DRIVER DOOR). Refer to  REMOVAL [09/2014 - ]