Installation [08/2016 - ]: Procedure
- INSTALL ACCELERATION SENSOR
- Install the acceleration sensor with the 2 nuts.
Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf)
NOTE:- Avoid any impact to the acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
- Connect the connector.
- Return the floor carpet to its original position.
- Install the acceleration sensor with the 2 nuts.
- INSTALL FRONT DOOR OPENING TRIM COVER LH
Refer to PROCEDURE - Step 37 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 36 [11/2017 - ]
- INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 38 [09/2014 - 11/2017] , or refer to PROCEDURE - Step 37 [11/2017 - ]
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [08/2016 - 11/2017] , or refer to INITIALIZATION [11/2017 - 03/2019] , or refer to INITIALIZATION [03/2019 - 01/2023] , or refer to INITIALIZATION [01/2023 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]