Installation [01/2023 - ]: Procedure

INSTALL ACCELERATION SENSOR ASSEMBLY

Install the acceleration sensor assembly with the bolt.

for Type A

Torque: 8.4 N.m (86 kgf/cm, 74 in.lbf)

for Type B

Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)

NOTE:

Avoid any impact to the acceleration sensor assembly.
Do not drop the acceleration sensor assembly. If it is dropped, replace it with a new one.
There are 2 types of bolts and the tightening torque depends on the type of bolt used as shown in the illustration. Therefore, confirm the tightening torque before installing the bolt.

*A	for Type A
*B	for Type B

INSTALL LUGGAGE COMPARTMENT TRIM COVER RH
Refer to PROCEDURE - Step 5
INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 10
INSTALL FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 11
INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 2
INSTALL REAR LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 13
INSTALL SPARE WHEEL COVER TRAY (w/o Spare Tire)
Refer to PROCEDURE - Step 14
INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 15
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [01/2023 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]