Removal [01/2023 - ]: Procedure
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [11/2017 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [01/2023 - 10/2023] , or refer to INITIALIZATION [10/2023 - ]
- REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/o Spare Tire)
Refer to PROCEDURE - Step 5
- REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM COVER (w/ Spare Tire)
Refer to PROCEDURE - Step 6
- REMOVE SPARE WHEEL COVER TRAY (w/o Spare Tire)
Refer to PROCEDURE - Step 7
- REMOVE REAR LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 8
- REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY
Refer to PROCEDURE - Step 1
- REMOVE FRONT UPPER LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 10
- REMOVE FRONT LUGGAGE COMPARTMENT TRIM COVER
Refer to PROCEDURE - Step 11
- SEPARATE LUGGAGE COMPARTMENT TRIM COVER RH
Refer to PROCEDURE - Step 11
- REMOVE ACCELERATION SENSOR ASSEMBLY
- Turn back the luggage compartment trim cover RH until the acceleration sensor assembly can be seen.
- Disconnect the connector.
- Remove the bolt and acceleration sensor assembly.NOTE:
- Avoid any impact to the acceleration sensor assembly.
- Do not drop the acceleration sensor assembly. If it is dropped, replace it with a new one.