Installation [09/2014 - ]: Procedure

HINT: 

Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.

1. Clean the bolt and bolt hole.
2. Apply adhesive to 2 or 3 threads on the end of the bolt.

   Adhesive

   Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

3. Temporarily install the park/neutral position switch assembly to the automatic transmission assembly with the bolt.

   HINT: 

   Tighten the bolt to the specified torque when adjusting the park/neutral position switch assembly.

4. Install a new lock washer and the lock nut to the park/neutral position switch assembly.

   Torque: 6.9 N.m (70 kgf/cm, 61 in.lbf) 

5. Temporarily install the transmission control shaft lever RH to the manual valve lever shaft with the spring washer and nut.

   HINT: 

   Tighten the nut to the specified torque when adjusting the park/neutral position switch assembly.

6. Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Transmission Control Shaft Lever RH
   *a	P
   *b	R
   *c	N

7. Remove the nut, spring washer and transmission control shaft lever RH from the manual valve lever shaft.
8. Align the neutral basic line with the groove as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Neutral Basic Line
   *b	Groove

9. Hold the park/neutral position switch assembly in that position and tighten the bolt.

   Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

10. Using a screwdriver, bend down the tabs of the lock washer.

    HINT: 

    Bend at least 2 of the lock washer tabs.

11. Install the transmission control shaft lever RH to the manual valve lever shaft with the spring washer and nut.

    Torque: 15.7 N.m (160 kgf/cm, 12 ft.lbf) 

12. Connect the park/neutral position switch assembly connector.
13. Tilt up the automatic transmission assembly.

1. Connect the rear engine mounting member to the vehicle body with the 4 bolts.

   Torque: 34.7 N.m (354 kgf/cm, 26 ft.lbf) 

1. Install the engine under cover air guide bracket to the vehicle body with the 2 bolts.

   Torque: 25.5 N.m (260 kgf/cm, 19 ft.lbf) 

1. Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lever
   	Rear of the vehicle

2. Temporarily install the nut to the lever of the transmission floor shift assembly.
3. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

   Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

   NOTE:

   Do not push the lever of the transmission floor shift assembly too hard.

Refer to INSTALLATION [09/2014 - 01/2023] , or refer to INSTALLATION [01/2023 - ]

See step  1

See step  1