Installation [09/2014 - ]: Procedure

1. Temporarily install the transmission floor shift assembly to the vehicle body with the 4 bolts.
   NOTE:

   Do not pinch the wire harness.

   Fig 1: Transmission Floor Shift Assembly Bolt Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Fully tighten the 4 bolts in the order shown in the illustration to install the transmission floor shift assembly.

   Torque: 8.3 N.m (85 kgf/cm, 73 in.lbf) 

3. Connect the transmission control switch connector.
   NOTE:

   Be sure to securely connect the transmission control switch connector.

4. Engage the 4 clamps to connect the wire harness to the transmission floor shift assembly.
5. Connect the shift lock control ECU connector.
   NOTE:

   Be sure to securely connect the shift lock control ECU connector.

1. Install the No. 1 console box duct with the 2 clips.
2. Engage the clamp to connect the wire harness to the No. 1 console box duct.

Refer to INSTALLATION [09/2014 - 03/2019] , or refer to INSTALLATION [03/2019 - ]

1. Turn the transmission control shaft lever RH counterclockwise until it stops, then turn it clockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Transmission Control Shaft Lever RH
   *a	P
   *b	R
   *c	N

2. Move the shift lever to N.
3. Connect the floor shift gear shifting rod sub-assembly to the lever of the transmission floor shift assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Lever
   	Rear of the vehicle

4. Temporarily install the nut to the lever of the transmission floor shift assembly.
5. Tighten the nut while lightly pushing the lever of the transmission floor shift assembly toward the rear of the vehicle.

   Torque: 12.8 N.m (131 kgf/cm, 9 ft.lbf) 

   NOTE:

   Do not push the lever of the transmission floor shift assembly too hard.

Refer to PROCEDURE - Step 5 [09/2014 - 01/2023] , or refer to PROCEDURE - Step 5 [01/2023 - ]

Refer to INSTALLATION [09/2014 - 10/2015] , or refer to INSTALLATION [10/2015 - 03/2019] , or refer to INSTALLATION [03/2019 - ]

1. Engage the 2 claws to install the shift lever cap to the shift position indicator.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Groove

   NOTE:

   Install the shift lock release button cover with its groove facing the rear of the vehicle.

See step  1

Refer to PROCEDURE - Step 9 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 9 [10/2015 - 03/2019] , or refer to PROCEDURE - Step 9 [03/2019 - ]