Installation [10/2018 - 07/2022]: Procedure

Refer to PROCEDURE - Step 1

HINT: 

Perform "Inspection After Repair" after replacing an ignition coil assembly.

Refer to INITIALIZATION [10/2018 - 08/2021] Refer to INITIALIZATION [08/2021 - 07/2022]

1. Using an 8 mm socket wrench, install the 4 ignition coil assemblies to the cylinder head cover sub-assembly with the 4 bolts.

   Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

   NOTE:

   If an ignition coil assembly has been struck or dropped, replace it.

   HINT: 

   Install the same parts to their original positions.

2. Connect the 4 ignition coil assembly connectors.

Refer to PROCEDURE - Step 41 Refer to PROCEDURE - Step 41

1. Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.

   Refer to INITIALIZATION [10/2018 - 08/2021] Refer to INITIALIZATION [08/2021 - 07/2022]