Installation [10/2023 - ]: Procedure

INSTALL ACCELERATION SENSOR ASSEMBLY

for LH Side:

Connect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Install the acceleration sensor with the 2 nuts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
NOTE:
- Avoid any impact to the acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
Return the floor carpet to its original position.

for RH Side:

Connect the connector.

Install the acceleration sensor with the 2 nuts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)
NOTE:
- Avoid any impact to the acceleration sensor.
- Do not drop the acceleration sensor. If it is dropped, replace it with a new one.
Return the floor carpet to its original position.

INSTALL COWL SIDE TRIM BOARD LH
Refer to PROCEDURE - Step 33
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 34
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 35
INSTALL FRONT DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 42
INSTALL COWL SIDE TRIM BOARD RH
HINT:

Use the same procedure described for the LH side.
INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 38
INSTALL INSTRUMENT SIDE PANEL RH
Refer to PROCEDURE - Step 39
INSTALL FRONT DOOR SCUFF PLATE RH
HINT:

Use the same procedure described for the LH side.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Refer to INSTALLATION [10/2023 - ]
PERFORM INITIALIZATION
Refer to VEHICLE IDENTIFICATION INFORMATION REGISTRATION [10/2023 - ]
INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL
Refer to WORK PROCEDURE [10/2023 - ]

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Refer to AUTOMATIC LEARNING CHART [10/2023 - ]