Removal [11/2021 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Refer to PROCEDURE - Step 2
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 23 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 23 [03/2024 - ] - REMOVE RADIATOR UPPER AIR GUIDE PLATE
Refer to PROCEDURE - Step 1 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 1 [03/2024 - ]
- REMOVE INLET AIR CLEANER ASSEMBLY
See step 4
- DISCONNECT VACUUM HOSE
See step 5
- DISCONNECT NO. 2 VENTILATION HOSE
See step 6
- REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
See step 7
- REMOVE ECM
- Rotate the 3 levers while pushing the locks, and disconnect the 3 ECM connectors.NOTE:
After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.
- Remove the 2 bolts, nut and ECM.NOTE:
If the ECM has been struck or dropped, replace it.
- Rotate the 3 levers while pushing the locks, and disconnect the 3 ECM connectors.
- REMOVE NO. 1 ECM BRACKET
- REMOVE NO. 2 ECM BRACKET