April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [12/2021 - ]: Procedure

INSTALL SPARK PLUG

Refer to PROCEDURE - Step 1

INSTALL IGNITION COIL ASSEMBLY

GTY1081235

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*A

for Bank 1

*B

for Bank 2

Install the 6 ignition coil assemblies with the 6 bolts.
Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf)

NOTE:
If an ignition coil assembly has been struck or dropped, replace it.
Connect the 6 ignition coil assembly connectors.

INSTALL BRACKET
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
CONNECT PURGE VSV (DUTY VACUUM SWITCHING VALVE)
CONNECT NO. 1 VENTILATION PRESSURE SENSOR HOSE
CONNECT NO. 4 WATER BY-PASS PIPE
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
CONNECT ENGINE WIRE
Torque: 10 N.m (102 kgf/cm, 7 ft.lbf)
INSTALL V-BANK COVER SUB-ASSEMBLY
PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
  - w/ Canister Pump Module:
    Refer to INITIALIZATION [12/2021 - ]
  - w/o Canister Pump Module:
    Refer to INITIALIZATION [12/2021 - ]