Removal [09/2023 - ]: Procedure
- REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY
- for 1Motor-HEV Model:
Refer to PROCEDURE - Step 22
- for Gasoline Model:
Refer to PROCEDURE - Step 25
- for 1Motor-HEV Model:
- REMOVE NO. 3 ENGINE COVER
- for 1Motor-HEV Model:
Refer to PROCEDURE - Step 23
- for Gasoline Model:
Refer to PROCEDURE - Step 26
- for 1Motor-HEV Model:
- REMOVE CAMSHAFT POSITION SENSOR (for Intake Side)
- Disconnect the camshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the camshaft position sensor.
- Remove the O-ring from the camshaft position sensor.
NOTE:- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.
- If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.
- REMOVE CAMSHAFT POSITION SENSOR (for Exhaust Side)
- Disconnect the camshaft position sensor connector.
- Using an 8 mm socket wrench, remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- Perform this procedure only when reusing the camshaft position sensor.
- Remove the O-ring from the camshaft position sensor.
NOTE:- Make sure to only remove the O-ring with bare hands.
- When removing the O-ring, be careful not to damage the O-ring groove of the camshaft position sensor.
- If the O-ring groove of the camshaft position sensor is damaged, replace the camshaft position sensor with a new one.