Work Procedure

WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

Perform action test to verify the customer's concern.
Perform action test and check the system operation after system diagnosis.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION:

Fully understand the following items well before the road test;
- System description for DAA: Refer to SYSTEM DESCRIPTION .
- Handling Precaution: Refer to Precautions for Driver Attention Alert (DAA) HANDLING PRECAUTION .

CHECK DAA SYSTEM SETTING
1. Start the engine.
2. After starting the engine wait for 30 seconds or more.
3. Check that the DAA system setting can be enabled/disabled on the information display.
4. Turn OFF the ignition switch and wait for 5 seconds or more.
5. Check that the previous setting is saved when the engine starts again.
>>

GO TO 2.

ACTION TEST FOR DAA

Enable the setting of the DAA system on the information display.
Check the DAA operation according to the following table.

Vehicle condition/Driver's operation	Display on combination meter
DAA OFF	-
DAA ON	Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

INSPECTION END