LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2022 >> Outlander ES, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 72 (Driver Assistance System) >> Basic Inspection >> Camera Aiming Adjustment >> Work Procedure >> Target Setting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Target Setting

WARNING: This page is about a different car, the 2024 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Be sure to place the target correctly according to work procedures because the system may not operate normally.
  • Perform this operation in a horizontal position where there is a clear view for 5 m (16.4 ft) forward and 3 m (9.84 ft) wide.
  • Place the target in a well-lighted location. (Poor lighting may make it hard to adjust.)
  • The target may not be detected when there is a light source within 1.5 m (4.92 ft) from either side and within 1 m (3.28 ft) upward/downward from the target.
  • Check the location of the sun. (Sunlight should not shine directly on the front of the vehicle.)
  • The target may not be detected when there is the same pattern of black and white as the target when the pattern is within 1 m (3.28 ft) from either side and upward/downward position from the target. (It is desirable that the vehicle is positioned on the opposite side of a single-color wall.)
  1. TARGET SETTING
    G16265369Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    A - E (C - F): 3, 000 mm (118.11 in) 

    1. Mark points "A", "B", "C" and "D" at the center of the lateral surface of each wheels.
      G16265370Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
      NOTE: *Hang a string with a cone from the fender so as to pass through the center of wheel, and then mark a point at the center of the lateral surface of the wheel.
    2. Draw line "LH" passing through points "A" and "B" on the left side of vehicle.
      NOTE: Approximately 4 m (13.12 ft) or more from the front end of vehicle.
    3. Mark point "E" on the line "LH" at the positions 3, 000 mm (118.11 in) from point "A".
    4. Draw line "RH" passing through points "C" and "D" on the right side of vehicle in the same way as step 2.
      NOTE: Approximately 4 m (13.12 ft) or more from the front end of vehicle.
    5. Mark point "F" on the line "RH" at the positions 3, 000 mm (118.11 in) from point "C".
    6. Draw line "FW" passing through the points "E" and "F" on the front side of vehicle.
    7. Mark point "X" at the center of point "E" and "F" on the line "FW".
      CAUTION: Make sure that "E" to "X" is equal to "F" to "X".
    8. Center the J-52266-2 alignment target at point "X" facing the vehicle.
      G16265371Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

    >>

    Proceed to

    Camera Aiming Adjustment  .

scientia non olet · About LEMON Manuals