Dual Led System (5 Modes)
- Turn ignition switch to ON position. Use a screwdriver to turn ECU diagnostic mode selector fully clockwise.
- Wait for inspection lights to begin flashing. At this time, inspection lights will flash the mode options (i.e. 2 flashes for Mode II, etc.). As soon as inspection light flashes the desired mode number (3 flashes for Mode III), immediately turn mode selector off.
- If the mode selector is kept in the ON position, the mode selections will continuously cycle (Mode I to Mode II up to Mode V, then cycles to Mode I, etc.) and the process will continue. This will not erase the memory.