Surge While Cruising
- Ensure there are no vacuum leaks into intake system.
- Ensure ignition timing is within specification.
- Check EGR control valve operation.
- Check EGR control valve solenoid operation.
- Remove vacuum hose from fuel pressure regulator and monitor for symptom change.
- Ensure fuel pressure is within specification.
- For Idle Switch: Enter self-diagnostic Mode IV and perform appropriate switch tests.
- For Crank Angle Sensor, Airflow Meter, Ignition Signal & Exhaust Gas Sensor: Center self-diagnostic Mode III and retrieve codes. If vehicle will not start, crank engine before entering self-diagnostic Mode III.
- For Crank Angle Sensor, Airflow Meter, Ignition Signal & Exhaust Gas Sensor: Enter self-diagnostic Mode V and monitor real-time diagnostic setting of fault codes. Perform appropriate code chart in TESTS W/CODES article.
- Disconnect exhaust gas sensor and monitor change in driveability. If it improves, replace sensor. If not, go to 11.
- Enter self-diagnostic Mode II and monitor fuel metering system operation.