Check Component Using Consult Tester (J-38465)

Turn ignition off. Connect Consult tester. Connect EGR valve, canister control solenoid valve and ECM harness connector. Turn ignition on. Perform EGRC SOL/V CIRCUIT in FUNCTION TEST mode. Turn EGR and canister control solenoid valve on and off using Consult tester in ACTIVE TEST mode. Replace EGR and canister control solenoid valve if operating sounds are not heard. Perform FINAL CHECK  .

Fig 1: Locating EGR & Canister Control Solenoid Valve Harness Conn. (Sentra)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: DTC 32, Checking Control Function (Sentra)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 3: DTC 32, Checking Output Signal Circuit (Sentra)

Courtesy of NISSAN MOTOR CO., U.S.A.