LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 1996 >> Sentra GLE, Automatic >> Repair and Diagnosis >> Engine Performance >> Sensor Range Charts >> Engine Controls - Sensor Operating Range Charts 1.6L >> Sensor Range Charts
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor Range Charts

Sensor operating range information can help determine if a sensor is out of calibration. An out-of-calibration sensor may not set a trouble code, but it may cause driveability problems.

NOTE: Perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure. To identify ECU terminals, see wiring diagram in the WIRING DIAGRAMS article.
CRANKSHAFT POSITION SENSOR RESISTANCE - @ 77°F (25°C)

Application Ohms
1.6L Engine (With A/T) 166-204
1.6L Engine (With M/T) 432-528
ENGINE (COOLANT) TEMPERATURE SENSOR RESISTANCE

Temperature °F (°C) Ohms
68 (20) 2100-2900
122 (50) 680-1000
176 (80) 300-330
194 (90) 236-260
EXHAUST GAS TEMPERATURE SENSOR RESISTANCE

Temperature °F (°C) Ohms
212 (100) 76,770-93,830
INTAKE AIR TEMPERATURE SENSOR RESISTANCE

Temperature °F (°C) Ohms
68 (20) 2100-2900
122 (50) 680-1000
176 (80) 300-330
194 (90) 236-260
KNOCK (DETONATION) SENSOR RESISTANCE - @ 77°F (25°C)

Application Ohms
Sentra 500,000-620,000
MASS AIRFLOW SENSOR VOLTAGE TEST (1)

Application Volts (2) With KOEO Volts At Idle
Sentra Less Than 1.0 1.0-1.7
(1) Values are approximate and vary with engine RPM.
(2) Key On, Engine Off.
OXYGEN SENSOR OPERATING RANGE

Application Volts
Front Oxygen Sensor About .35-.60
Rear Oxygen Sensor About .55-.60
OXYGEN SENSOR HEATER ELEMENT RESISTANCE - @ 77°F (25°C)

Application Ohms
Front HO2S 3.3-6.3
Rear HO2S 5.2-8.2
POWER STEERING OIL PRESSURE SWITCH

Condition Continuity
Steering Unloaded (Not Turning Steering Wheel) No
Steering Loaded (Turning Steering Wheel) Yes
THROTTLE POSITION SENSOR RESISTANCE TEST (1)

Application Wire Colors k/Ohms
Sentra Yellow & Black 0.6-4.0
(1) Ensure resistance changes when opening/closing throttle.