DTC P0120: Throttle Position (TP) Sensor: Notes

NOTE: Using the following diagnostic procedure assumes the presence of a current (hard) DTC or the ability to duplicate the setting of the DTC using described procedures (see DTC CONFIRMATION), intermittent recreation procedures or a test drive under conditions stored in freeze frame data. See TESTING PROCEDURE under SELF-DIAGNOSTIC SYSTEM in TESTS W/CODES - INTRODUCTION article. If DTC cannot be duplicated, proceed to TESTS W/O CODES article for diagnosis by symptom.

NOTE: Perform the following DTC confirmation tests in order. Check for DTC after each DTC confirmation test is performed. If DTC is set, see appropriate procedure for testing. See DTC CONFIRMATION IDENTIFICATION (DTC P0120) table.