DTC Confirmation Test (Using CONSULT-II)

NOTE: Before performing test, ensure fuel tank level is 1/4-3/4, ambient temperature is 32-86°F (0-32°C) and EVAP-CPVCSV hoses are installed correctly. Open hood before proceeding.

Turn ignition on. Turn ignition off and wait at least 5 seconds. Turn ignition on and select DATA MONITOR mode with CONSULT-II.
Ensure the following conditions are met:
2.4L Models
- COOLAN TEMP/S: 32-158°F (0-70°C).
- INT/A TEMP SE: 32-140°F (0-60°C).
3.3L Models
- COOLAN TEMP/S: 32-90°F (0-32°C).
- INT/A TEMP SE: more than 32°F (0°C).
Select EVP SML LEAK P0442/P1442 of EVAPORATIVE SYSTEM in DTC WORK SUPPORT mode with CONSULT- II. Follow instructions displayed.
NOTE: If engine speed cannot be maintained within range displayed on CONSULT-II screen, perform BASIC INSPECTION. See ON-VEHICLE ADJUSTMENTS article.
If OK is displayed on CONSULT-II, system is okay at this time. If NG is displayed, go to DIAGNOSTIC PROCEDURE .