LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Nissan-Datsun >> 2002 >> Maxima GLE >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Self-Diagnostics >> Diagnostic Tests >> DTC P0453: EVAP Control System Pressure Sensor High Input >> DTC Confirmation Test (Using Generic Scan Tool)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Confirmation Test (Using Generic Scan Tool)

CAUTION: DO NOT use ECM ground terminals when measuring voltage.
  1. Start engine and warm to normal operating temperature. Measure voltage between ground and fuel tank temperature sensor signal circuit at ECM terminal No. 75 (Pink/Blue wire) by backprobing. See Figure and Figure . Ensure voltage is less than 4.2 volts.
  2. Turn ignition off and wait at least 10 seconds. Start engine and wait at least 20 seconds. Select MODE 7 with scan tool. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  . If 1st trip DTC is not detected, system is okay at this time.
scientia non olet · About LEMON Manuals