Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

Remove center console lower cover. Refer to "REMOVAL AND INSTALLATION ".
Remove yaw rate/side/decel G sensor attaching nuts.
CAUTION:
- Do not use power tools to remove or install yaw rate/side/decel G sensor.
- Do not drop or strike the yaw rate/side/decel G sensor.
Fig 1: Removing Yaw Rate/Side/Decel G Sensor Attaching Nuts - With Torque Specifications
Courtesy of NISSAN MOTOR CO., U.S.A.
Disconnect harness connector and remove the yaw rate/side/decel G sensor.