Room/Map Lamp Control Does Not Operate

Select "BCM" on CONSULT-II. With "INT LAMP" data monitor, make sure switches listed in display item list turn ON-OFF linked with switch operation. Refer to "DISPLAY ITEM LIST " for switches and their functions.

OK or NG

• OK: GO TO 2.
• NG: Inspect malfunctioning switch system.
  Fig 1: Displaying DATA MONITOR Mode Screen

  Courtesy of NISSAN MOTOR CO., U.S.A.

1. Select "BCM" on CONSULT-II. Select "INT LAMP" active test.
   Fig 2: Displaying INT LAMP On ACTIVE TEST Screen

   Courtesy of NISSAN MOTOR CO., U.S.A.
2. When lamps on demand switch is in "DOOR" position, use active test to make sure interior room lamp operates.

OK or NG

• OK: Replace BCM. Refer to "REMOVAL AND INSTALLATION OF BCM ".
• NG: GO TO 3.

1. Turn ignition switch OFF.
2. Check voltage between room/map lamp harness connector R9 terminal 1 (R/G) and ground.
   Fig 3: Checking Voltage Between Room/Map Lamp Harness Connector R9 Terminal 1 & Ground

   Courtesy of NISSAN MOTOR CO., U.S.A.

   1 (R/G) - Ground: Battery voltage should exist. 

OK or NG

• OK: GO TO 4.
• NG: GO TO  6.

1. Disconnect lamps on demand switch connector.
2. Check continuity between lamps on demand switch terminals.
   Fig 4: Checking Continuity Between Lamps On Demand Switch Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.
   Fig 5: Terminals Continuity Reference Chart

   Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

• OK: GO TO 5.
• NG: Replace lamps on demand switch.

1. Connect lamps on demand switch connector.
2. Turn lamps on demand switch to DOOR position.
3. Disconnect BCM connector.
4. Check continuity between BCM harness connector M19 terminal 48 (P) and lamps on demand switch harness connector M108 terminal 3 (P).

   (P) - 3 (P): Continuity should exist. 

OK or NG

• OK: Replace BCM if interior lamp does not work after setting the connector again. Refer to "REMOVAL AND INSTALLATION OF BCM ".
• NG: Repair harness or connector.
  Fig 6: Checking Continuity Between BCM Harness Connector M19 Terminal 48 & Lamps On Demand Switch Harness Connector M108 Terminal 3

  Courtesy of NISSAN MOTOR CO., U.S.A.

1. Disconnect BCM connector and interior room lamp connector.
2. Check continuity between BCM harness connector M19 terminal 41 (R/G) and interior room/map lamps harness connector R9 terminal 1 (R/G).
   Fig 7: Checking Continuity Between BCM Harness Connector M19 Terminal 41 Interior Room/Map Lamps Harness Connector R9 Terminal 1

   Courtesy of NISSAN MOTOR CO., U.S.A.

   41 (R/G) - 1 (R/G): Continuity should exist. 

OK or NG

• OK: Replace BCM if interior lamp does not work after setting the connector again. Refer to "REMOVAL AND INSTALLATION OF BCM ".
• NG: Repair harness or connector between BCM and room/map lamp or between room/map lamp and lamps on demand switch.