Illumination Control Switch Inspection

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Symptom: Illumination control does not operate.

CHECK CONNECTOR
1. Turn ignition switch OFF.
2. Remove combination meter. Refer to "REMOVAL AND INSTALLATION FOR COMBINATION METER ".
3. Remove rear finisher to combination meter. Refer to "DISASSEMBLY AND ASSEMBLY FOR COMBINATION METER ".
4. Check illumination control switch connector for looseness.
OK or NG
- OK : GO TO 2.
- NG : Repair illumination control switch connector.
CHECK ILLUMINATION CONTROL SWITCH
1. Disconnect illumination control switch connector.
2. Check continuity between illumination control switch harness connector M207 terminals 3 or 4 and 5.
  
  Fig 1: Illumination Control Switch Harness Connector M207 Terminals 3 Or 4 & 5 Continuity Specifications Table
  Courtesy of NISSAN MOTOR CO., U.S.A.
  
  Fig 2: Illumination Control Switch Harness Connector M207 Terminals 3 Or 4 & 5 Continuity Test
  Courtesy of NISSAN MOTOR CO., U.S.A.
OK or NG
- OK : Replace combination meter.
- NG : Replace illumination control switch.